@geedup | ||
my toshiba portege R100 fell on d ground and i tried putting it on,it indicates dat power is activated as on d indicator lights on d side but doesnt display d toshiba logo on startup,it just displays a black screen as if its not turned on yet. Plz guru what do i do? |
||
11
Replies
579
Views
0 Favourites
|
Page #: 1/2 |
@the.rain | 28 December 10 | |
*
look under it on the botton there should be some access panels, remove them, they will give you access to the ram cards and hard drive, check to see they have not come lose, then try rebooting again
|
||
@geedup | 28 December 10 | |
@the.rain,i have tried doing all that but 2 no avail. What else do u think could be d problem...thanx
|
||
@geedup | 28 December 10 | |
sometimes it comes on but its nt steady
|
||
@jay.mack | 28 December 10 | |
sounds like you may have cracked the motherboard. get it checked by a pro.
|
||
@geedup | 28 December 10 | |
@jaymack,if thats d case then what should i do?
|
||
@mok214 | 28 December 10 | |
Hmm , it might make a good doorstop or paper weight .
|
||
@dskelly | 28 December 10 | |
The power inverter to lcd is maybe damage i had same in toshiba after small drop to it..it was repair but expensive and afterwards could see specks of dust or something behind lcd :(
|
||
@karentv | 28 December 10 | |
can you hear any normal startup sounds coming from it? if not, i'd say motherboard damage at best, get find a pro and get it looked at.
|
||
@foooku | 28 December 10 | |
If you can hear the hdd Id also suspect display psu is kinda fked .
|
||
@codemast | 28 December 10 | |
That your bird to the shop
|
||